Lars wrote:
Can you specialists me advise please. I want to be able to switch a
small speaker on and off.

The speaker is attached to a small stereo (approx 15W + 15W) which
has one speaker in the kitchen and one in the hallway.

Is it ok to simply put a switch in the speaker lead? I am concerned
about two things with this approach:

(a) The on/off action may cause transients which may damage the
amplifier.

(b) The lack of any load on one channel may cause the amplifier to
have a shorter life than otherwise.



Any advice gratefully received. Thank you.

most amplifiers have switches for two sets of speakers that do just that.


--
Return address is VALID.
500MHz Tek DSOscilloscope TDS540 $2100
Wanted, 12.1" LCD for Gateway Solo 5300. Samsung LT121SU-121
Bunch of stuff For Sale and Wanted at the link below.
http://www.geocities.com/SiliconValley/Monitor/4710/

"Lars" wrote in message
...
Can you specialists me advise please. I want to be able to switch a
small speaker on and off.

The speaker is attached to a small stereo (approx 15W + 15W) which
has one speaker in the kitchen and one in the hallway.

Is it ok to simply put a switch in the speaker lead? I am concerned
about two things with this approach:

(a) The on/off action may cause transients which may damage the
amplifier.

(b) The lack of any load on one channel may cause the amplifier to
have a shorter life than otherwise.

Any advice gratefully received. Thank you.

Lack of load shouldn't hurt a modern solid state amplifier. But if
you're concerned, switch a load of a 20 to 30 ohm, 10 watt resistor in
place of the speaker.

"Lars" wrote in message
...
| Can you specialists me advise please. I want to be able to switch a
| small speaker on and off.
|
| The speaker is attached to a small stereo (approx 15W + 15W) which
| has one speaker in the kitchen and one in the hallway.
|
| Is it ok to simply put a switch in the speaker lead? I am concerned
| about two things with this approach:
|
| (a) The on/off action may cause transients which may damage the
| amplifier.

Only with a tube amplifier.

| (b) The lack of any load on one channel may cause the amplifier to
| have a shorter life than otherwise.

Only with a tube amplifier.

| Any advice gratefully received. Thank you.

You could also put a 50 ohm pot in series.

N