I have a Yamaha RX-V2500 receiver. I have another amp connected to its
Zone 2 output so that I can send audio to another room. But the only
way this works is if I turn the REC OUT/ZONE 2 dial in the front of the
receiver to select a specific source.

I want to leave this dial on SOURCE/REMOTE so that whatever source I'm
currently playing on the main speakers will always be sent to Zone 2,
but when the dial is set to SOURCE/REMOTE, the receiver never sends any
audio to Zone 2.

What am I doing wrong - how do I get the receiver to automatically send
to Zone 2 whatever it's playing on the main speakers?

In . com, on 05/12/06
at 10:56 AM, "Brian Kendig" said:



I have a Yamaha RX-V2500 receiver. I have another amp connected to its
Zone 2 output so that I can send audio to another room. But the only
way this works is if I turn the REC OUT/ZONE 2 dial in the front of
the receiver to select a specific source.

I want to leave this dial on SOURCE/REMOTE so that whatever source I'm
currently playing on the main speakers will always be sent to Zone 2,
but when the dial is set to SOURCE/REMOTE, the receiver never sends
any audio to Zone 2.

What am I doing wrong - how do I get the receiver to automatically
send to Zone 2 whatever it's playing on the main speakers?

Keep in mind that digital signals are not converted to analog for the
benefit of REC OUT or Zone2 or Zone3.

I think that you'll make out better using REC OUT for your application
-- Note that you'll need to use the volume control on the external
amplifier.

-----------------------------------------------------------
spam:
wordgame:123(abc):14 9 20 5 2 9 18 4 at 22 15 9 3 5 14 5 20 dot 3 15
13 (Barry Mann)
[sorry about the puzzle, spammers are ruining my mailbox]
-----------------------------------------------------------