I just bought a ported bandpass box, with 2-10" holes.
Plexi front. The speakers will angle toward the plexi
and back at eachother.
My amp is a Rockford Fosgate 300 Bridgeable, i think
4 ohm output.
Speakers i think are 4 ohm.
If i parallel them and they are 4's, i should get 2 ohms.
I guess if they are 8's i am in just fine.
But should this type of box be wired push-pull???
Any advice appreciated in advance.
I do have a crossover that seems to have every adjustment
possible.
Please email

If you put 2 of 8 ohm speakers in parallel, you will have a 4 ohm load to
the amplifier. This is the approach I would think to use. You do not want
to put 2 ohms across your amplifier!

--

Greetings,

Jerry Greenberg GLG Technologies GLG
=========================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
Instruments http://www.zoom-one.com/glgtech.htm
=========================================


"Joe" wrote in message
m...
I just bought a ported bandpass box, with 2-10" holes.
Plexi front. The speakers will angle toward the plexi
and back at eachother.
My amp is a Rockford Fosgate 300 Bridgeable, i think
4 ohm output.
Speakers i think are 4 ohm.
If i parallel them and they are 4's, i should get 2 ohms.
I guess if they are 8's i am in just fine.
But should this type of box be wired push-pull???
Any advice appreciated in advance.
I do have a crossover that seems to have every adjustment
possible.
Please email