"JW" wrote in message
...
Hi,

I'm trying to find out if there is a way to connect the REC/Phones output
of
my Roland Micro Cube amplifier to a Microphone input on a laptop. Assuming
the Mic-In is low impedance, is there a way to convert the high voltage
line signal of the amp to the microphone input? All I found so far is to
do
the opposite: connecting a mic to a line input. Where can I buy such a
impedance matcher?

Also, I would like to know if it is ok to connect a 600 Ohm mic to a
10kOhm
mic input.

Does your laptop have a Mic Input but no Line Input ?!!!

geoff