[Trevor]

On 10/12/2014 11:21 PM, Mark Zacharias wrote:
In my experience the manufacturers are simply trying to reduce the
number of warranty repairs to some extent by specifying the higher
resistance. In truth, with a bit of common sense applied at the volume
control side of the equation, a four-ohm speaker will work just fine
with any solid state amp or surround receiver of even minimal quality,
such as Pioneer, Sony, Marantz, Denon, Kenwood, etc PROVIDED as I say,
some common sense is used and the user isn't trying to use the thing as
a sort of mini-PA system.

Problem is, people connect all sorts of speakers, even for example car
stereo speakers wired in unusual, often incompetent ways, then expect to
be able to blast away for hours on end.

Yamaha, for example, knows full well that one of their power
transformers will not have a failed thermal fuse in the power
transformer in the absence of customer abuse - playing the thing at a
very high level, probably with low impedance speakers (or combinations
of speakers) for an hour or two more or less continuous.

Therefore, they will only cover ONE power transformer under warranty.
The warranty servicer is expected to educate the customer that a second
transformer won't be covered.

In fact, the newest Yamaha's will "rat out" the user by recording how
high the volume was for more than one minute and how many times. This
info is accessible in the service menu.


Amazing isn't it that a manufacturer can incorporate watch dog
electronics in a receiver, but not simply a more sophisticated
protection circuit to prevent damage in the first place!
I'd be looking elsewhere if that's the case.

Trevor.