View Single Post
  #21   Report Post  
Posted to rec.audio.high-end
Trevor Wilson[_3_] Trevor Wilson[_3_] is offline
external usenet poster
 
Posts: 139
Default Audio Interconnect cable Performance - is Return Wire Diameter aFactor?

On 11/12/2020 11:29 pm, Peter Wieck wrote:
The Dynaco PAT-5 biFet makes 15V @ 50MA +/- 5%


**Umm, not quite. The specs for the LF357 indicates significantly lower
numbers than that. At 25 degrees C:

* Maximum output Voltage (god, I forgot just how primitive that old
things was - zener regulation!?), with a +/- 15 Volt supply - 25 Volts
p-p = 8.8 Volts RMS (theoretically).
* Maximum output current @ 25 V p-p (dunno what the value of the output
series resistor is, as that will change the final figure somewhat) - +ve
20ma and (wait for it) -ve 5ma.

There is an Aktika (sp?) pre-amp that makes 20V @ 50MA +/- 5%
And there is a mod for the PAT-5 to get it to 42V @ 20MA +/- 5%

The reasoning for those superficially absurd voltages is headroom. And that is a long, difficult, and very nearly futile discussion mostly based on revealed religion.


**Well, once the input Voltage limits of the power amp are exceeded,
it's all over red rover.


And, that is AC voltage. Not DC - so those electrons are flying back and forth at whatever the audio frequency might be. Not departing for parts-unknown and in only one direction.


**Of course.


--
Trevor Wilson
www.rageaudio.com.au

--
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus